Airtac Type SDA12X45 Compact Air Cylinders 12mm Bore 45mm Stroke
Shop for Airtac type SDA series compact air cylinders. These
pneumatic actuators are available as multi-mount, pancake, double
acting, single acting (push), single acting (pull) and double rod.
Choose from multiple bore and stroke sizes. Compact cylinders are
also referred to as mini cylinders, small cylinders or mini
Specifications of SDA Series Pneumatic Cylinder:
|Bore Size (mm)||12||16||20||25||32||40||50||63||80||100|
|Acting Type||Double Acting|
|Single Acting_ Push Type, Single Acting_Pull Type||-|
|Fluid||Air (to be filtered by 40μm filter element)|
|Operating Pressure Range||Double Acting||0.15 to 1.0 MPa (1.5 to 10.0 bar) (22 to 145 psi)|
|Single Acting||0.2 to 1.0 MPa (2.0 to 10.0 bar) (28 to 145 psi)|
|Proof Pressure||1.5 MPa (15 bar) (215 psi)|
|Temprature (℃)||-20 to +70|
|Speed Range (mm/s)||Double Acting: 30 to 500, Single Acting: 50 to 500|
|Port Size||M5 x 0.8||1/8''||1/4''||3/8''|
Stroke of SDA Series Pneumatic Cylinder:
Symbol of SDA Series Pneumatic Cylinder:
Ordering Code of SDA Series Pneumatic Cylinder:
Criteria for selection: Cylinder thrust:
Installation & Usage:
1. When load changes in the wonk, the cylinder wih abundant output
capacity shall be ed.
2. Relative cylinder wth high temperature resistance or corrosion
resistance shall be chosen under the condition of high temperature
3. Necessasy protection measure shall be taken in the evironment
with higher humidity. much dust or water drops, oil dust and
4. Dirty substances in the pipe must be eliminated before cylinder
is connected with pipeline to prevent the entrance of particles
into the cylinder.
5. The medium used by cyinder shall be fitered to 40μm or below.
6. As both of the front cover and piston of the cylinder are short.
typically too large stroke can not be ed.
7. Anti-freezing measure shall be adopted under low temperature
environment prevent moisture freezing.
8. The cylinder shall avoid the inluence of side load in operation
to maintain the normal work of cylinder and extend the service
9. If the cylinder is dismantled and stored for a long time, please
conduct anti-rust treatment to the surface. Anti-dust caps shall be
added in air inlet and outlet ports. The front and back cover can
not be dismantled, which shall be especially noticed.
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!